Buildbot no longer supports Python 2.7 on the Buildbot master.
2.5.9. Build Sets¶
BuildSet represents a set of
Builds that all compile and/or test the same version of the source tree.
Usually, these builds are created by multiple
Builders and will thus execute different steps.
BuildSet is tracked as a single unit, which fails if any of the component
Builds have failed, and therefore can succeed only if all of the component
Builds have succeeded.
There are two kinds of status notification messages that can be emitted for a
firstFailure type (which fires as soon as we know the
BuildSet will fail), and the
Finished type (which fires once the
BuildSet has completely finished, regardless of whether the overall set passed or failed).
BuildSet is created with set of one or more source stamp tuples of
(branch, revision, changes, patch), some of which may be
None, and a list of
Builders on which it is to be run.
They are then given to the BuildMaster, which is responsible for creating a separate
BuildRequest for each
There are a couple of different likely values for the
(revision=None, changes=CHANGES, patch=None)
This is a
SourceStampused when a series of
Changes have triggered a build. The VC step will attempt to check out a tree that contains CHANGES (and any changes that occurred before CHANGES, but not any that occurred after them.)
(revision=None, changes=None, patch=None)
This builds the most recent code on the default branch. This is the sort of
SourceStampthat would be used on a
Buildthat was triggered by a user request, or a
Periodicscheduler. It is also possible to configure the VC Source Step to always check out the latest sources rather than paying attention to the
Changes in the
SourceStamp, which will result in same behavior as this.
(branch=BRANCH, revision=None, changes=None, patch=None)
This builds the most recent code on the given BRANCH. Again, this is generally triggered by a user request or a
(revision=REV, changes=None, patch=(LEVEL, DIFF, SUBDIR_ROOT))
This checks out the tree at the given revision REV, then applies a patch (using
patch -pLEVEL <DIFF) from inside the relative directory SUBDIR_ROOT. Item SUBDIR_ROOT is optional and defaults to the builder working directory. The
trycommand creates this kind of
None, the patching step is bypassed.
The buildmaster is responsible for turning the
BuildSet into a set of
BuildRequest objects and queueing them on the appropriate