Previous: WithProperties, Up: Using Build Properties


4.11.2.2 Common Build Properties

The following build properties are set when the build is started, and are available to all steps.

branch
This comes from the build's SourceStamp, and describes which branch is being checked out. This will be None (which interpolates into WithProperties as an empty string) if the build is on the default branch, which is generally the trunk. Otherwise it will be a string like “branches/beta1.4”. The exact syntax depends upon the VC system being used.
revision
This also comes from the SourceStamp, and is the revision of the source code tree that was requested from the VC system. When a build is requested of a specific revision (as is generally the case when the build is triggered by Changes), this will contain the revision specification. This is always a string, although the syntax depends upon the VC system in use: for SVN it is an integer, for Mercurial it is a short string, for Darcs it is a rather large string, etc.

If the “force build” button was pressed, the revision will be None, which means to use the most recent revision available. This is a “trunk build”. This will be interpolated as an empty string.

got_revision
This is set when a Source step checks out the source tree, and provides the revision that was actually obtained from the VC system. In general this should be the same as revision, except for trunk builds, where got_revision indicates what revision was current when the checkout was performed. This can be used to rebuild the same source code later.

Note that for some VC systems (Darcs in particular), the revision is a large string containing newlines, and is not suitable for interpolation into a filename.

buildername
This is a string that indicates which Builder the build was a part of. The combination of buildername and buildnumber uniquely identify a build.
buildnumber
Each build gets a number, scoped to the Builder (so the first build performed on any given Builder will have a build number of 0). This integer property contains the build's number.
slavename
This is a string which identifies which buildslave the build is running on.
scheduler
If the build was started from a scheduler, then this property will contain the name of that scheduler.
repository
The repository of the sourcestamp for this build
project
The project of the sourcestamp for this build